Hi,
David Fletcher has worked his magic with a Cad system, and in Arizona, Stan Cedarleaf did some superb printing with his ALPS printer of the 4 PDF's of transfers that then winged their way across the Atlantic to me - they are ion two colours gold and red.
When I had finished most of the work on my hotel it was time to start to add the transfers to my loco; there were a lot of them! Slowly they were added, a large amount of them being very small pieces: I finished off with the largest pieces of all - which were a complete sheet for each side of the bunker - those being just over 7" long and 2" deep - they having plenty of water underneath them happily went on very easily.
All have been varnished down tight, and although there are a small number of items that will need attention the loco is maily complete. The intention was to finish off the loco is its 'as delivered' state.
Here are some photos of it taken today when it was sunny (though the sun was fast disappearing behind the bulk of the house: it was cold but warmer than yesterday!
driver's side of the loco, from ground level with the loco of my photo location, on the trestle.
fireman's side with a 'bit sloping' photo - apologies for that I didn't notice it when taking the photo, it has beeen partially straightened but not enough as there would betoo much white in the upper left hand corner.
Low level view of drivers side.
Camera lifted up a bit showing more of the domes etc.
Two views of the rear - a couple of plans of this loco showed a number is a panel on the back of the bunker - so it was included in the transfers with the same design around it as the side panels. The vertical part of the bunker has three pieces - one per side: these are the largest pieces of the whole set.
Fireman's side top view, with a bit (oops!) of the 'cowcatcher' cut off
Two views of the loco with something to do - the first freight car is the largest that were built for the DSP&PRR - they were built to move Charcoal from the lineside Charcoal ovens (shaped like a beehive); they were so large that they were eventually fitted with standard gauge trucks and were the size of standard gauge boxcars. This was one of my earliest scratchbuilt boxcars.
a final top view, slightly out of focus, it shows the fireman's tools I have been making for my locos; there is a poker, a clinker buster, and a coal pick. The shovel is the Bachmann one.
Here is a better view - taken inside this time with the 'close up' switched on in the camera.
The tender is a different one - its not of the Big Mason Bogie, but a Baldwin tender.
The design is taken from the old Midland Railway style and they are made made from 1.25mm diameter brass wire, with the pick head made from scrap plastic. The brass wire will bend easier if its annealed in a gas flame: blackened with a blackening agent and trimmed in silver (where they would get worn from use).=
Enjoy!
<message edited by peterbunce on 16/01/12 03:04 PM>